THOMSON 780 (WL), User Manual

Page: 53 / 132

45
E-DOC-CTC-20051017-0149 v1.0
Chapter 4
Voice over IP
Using the services on
the phone
The following table explains how to use a telephony service. The commands
depend on your provider’s configuration and might be different from those
described here. For more information, see your provider’s documentation.
Make sure your phone is off-hook when you dial the commands.
If your phone does not have an R or another hook flash button, put down
the hook for 1/2 second and then dial the command number.
To use the service: Proceed as follows:
Call Hold To put person A on hold:
1 Dial R , 2 to put the call with person A on hold.
2
Dial R , 1 to retrieve the call on hold.
To put person A on hold and set up a call to person
B:
1
Dial R , 2 to put the call with person A on hold.
2
Wait for the dialling tone, and dial the number
of person B.
3
Dial R , 2 to switch back to person A.
Person B is put on hold.
Call Waiting You are in a phone conversation with person A
while person B is calling you. The phone produces
a waiting tone and - if CLIP is enabled and CLIR
disabled - displays the number of person B.
Do one of the following:
To reject the incoming call, dial R , 0 .
To terminate the first call and to switch to the
waiting call, dial
R , 1 .
If you do not want to terminate the first call,
dial
R , 2 to keep the first caller on hold while
answering the second call.
To return to person A while putting
person B on hold, dial
R , 2 .
To return to person A while terminating
the call with person B, dial
R , 1 .
Call Transfer You receive a phone call from person A and you
want to transfer him to person B.
1
Dial R , 2 .
2
Wait for the dialling tone.
3
Dial the number of person B.
Person B picks up the phone.
4
Dial R , 4 to transfer the call.
5
Hang up.