27
First issue 09 /03
Side Mask
It is brightness adjustment of a non-drawing part. It is at the time of the screen size “DOT BY DOT” and “4:3”. It can be adjusted
independently, R, G, B.
The default of a side mask differs from others.
When DEFAULT is a highlight, shortly after pushing O.K., it returns to a shipment value. And a value is changed and it returns to a
service menu.
Mask Control
If this mode is turned ON, a non-drawing portion will move. It is at the time of the screen size “DOT BY DOT” and “4:3”. Moreover,
whenever it turns on a power supply, a position moves. It is a kind in printing mitigation mode. It is usually ON.
Orbiter Mode
It is the mode that moves a little display position of a screen with progress of time. It carries out movement of 1 dot at intervals of
about 8 minutes. It is in a horizontal and vertical direction. Since there is fear of a nonsense claim, it is usually OFF.
Inverse Mode
It is the mode that reverses an image. In other words, it is negative & positive reversal. An effect may be in the emergency measure
of printing. Default is OFF.
Fan Control
It is the mode that changes control of FAN.
Adjustment range
Item
MIN
MAX
Default value
R(ed).LEVEL
0
255
80
G(reen).LEVEL
0
255
80
B(lue).LEVEL
0
255
80
MODE
An outline of operation
AUTO
The mode which controls FAN depending on the temperature sensor
inside PDP
MAX
It is not dependent on the sensor inside PDP.
This mode operates FAN at the maximum.
Usually, this mode is not used.
A default is AUTO.
