Thomashilfen EASyS Advantage, Instructions For Use Manual

Page: 25 / 32

2021-04
Backrest upholstery
The backrest upholstery is attached to the hook and loop strips on the back plate (Fig. 15). The lower part of the back-
rest upholstery is inserted to the rear between the seat and the back (Fig. 16). The lower end is provided with hook and
loop fastener and is attached to the rear end of the seat plate to close the gap between the seat and the back (Fig. 17).
Side cushion
Place the side cushions over the side tubes so that the onger side of the cushions is facing inward (Fig. 18). The hook and
loop fastener is located on the inside of the back plate curve. Attach the cushion in such a manner that the upper edge
of the cushion on the back ends just below the thumbscrew (Fig. 19). Then attach the rear of the cushion with hook and
loop to the outside of the back plate curve (Fig. 20). The zippers of the side cushion can be positioned inwards if neces-
sary.
Lateral seat upholstery
The lateral seat upholstery can be opened with a zipper. It is pulled over the seat side guides in such a manner that the
zipper on the outside runs from the rear / top to the front / bottom (Fig. 21).
Holders for sun and rain cover
The EASyS Modular S comes with holders for the sun and rain cover (without leg blanket) as standard (Fig. 22). Their
height can be adjusted as required. To do so, loosen the screws of the holders for the sun and rain cover and move it on
the tubes into the desired position. Then tighten the screws firmly again.
Calf strap
The calf strap is affixed between the two lateral posts of the footrest and supports the user’s lower legs. (Fig. 52)
Seat width
To adjust the seat width, loosen the four soft-touch nuts under the seat of the EASyS Modular S and move the side ele-
ments accordingly (Fig. 23). Then retighten the nuts. If the seat depth is set to the minimum depth, the maximum adjust-
able seat width depends on the gap before the lateral seat upholstery of the back.
Seat depth
Loosen the two front soft-touch nuts under the seat of the EASyS Modular S and pull the seat plate forwards (Fig. 23).
Then retighten the nuts.
Tip: To easily adjust the seat depth, use one hand to grip the front edge of the seat and use the other to hold the lower
end of the back (in the center) steady. The depth and height of the seat side guide can also be adjusted. To do so, open
the cushions of the seat side guides with the zippers and remove them. Loosen the two thumbscrews, set the desired
depth and height and retighten the screws (Fig. 24).
Back height
Loosen the two thumbscrews on the side tubes (Fig. 25). Now the height of the backrest can be infinitely adjusted up
to the engagement point (spring pins engage with a click). To reduce the back height, press the spring pins below the
thumbscrews and slide the back plate downwards to the desired height (Fig. 26).
Then retighten all the thumbscrews.
Tip: The extended tubular bar provides additional safety for children who are predominantly transported in the horizon-
tal position.
Angle of recline
Loosen the clamping lever on the backrest (Fig. 27) and remove the safety pin below the lever (Fig. 28). Now the back-
rest can be brought into the desired position. inally, retighten the clamping lever after the position has been set.
When transporting the rehab stroller in a vehicle, the safety pin must always engage into the hole (90° seat angle).
Instructions for Use – EASyS Modular S seat unit
25