7
Section
2:
Instruction
Manual
and
Drawings
*4t*4.73
Set-Up
WARNING:
Before installing, operating, maintaining or testing this equipment, carefully read and understand the
contents of this manual. Improper operation, handling or maintenance can result in death, severe personal injury
or equipment damage.
Set-up and testing of the recloser
can be performed at maintenance
facilities, test laboratories or directly
in the field once appropriate control
supply voltage is made available.
Connect the recloser to the
appropriate control:
t
Single-phase units — the MVR
should be connected to the
SEL
®
351RS Kestrel control via
a 10-pin interconnecting cable
t
SEL
®
651Rx2 control — the
MVR should be connected
to the control via a 32-pin
interconnecting cable
t
SEL
®
351R or 351R Falcon
control — the 14-pin cable
should be connected to the
MVR power module, and the
6-ft. 32-pin cable should be
used to connect the power
module to the MVR*
The recloser receives the necessary
signal to open and close from the
control circuitry. The control is
powered from an external supply
voltage but is also supplied with
a battery backup system that is
fully charged from the factory. The
battery backup system, located in
the control cabinet, is shipped in
the “off” or disconnected position.
For information on how to connect
the battery, please refer to the
appropriate SEL
®
control manual.
The figure at right shows a typical recloser, control and power supply interconnection layout.
I Ìi\Ê6,ÃÊÀ}>ÞÊ«ÕÀV >Ãi`ÊvÀÊÕÃiÊÜÌ ÊÌ iÊ-
®
ÊÎx£,ÊÀÊÎx£,Ê>VÊVÌÀÃÊ>ÀiÊ`iÃ}i`ÊÌÊLiÊi>ÃÞÊ
Õ«}À>`>LiÊvÀÊÕÃiÊÜÌ ÊÌ iÊ-
®
ÊÈx£,ÊVÌÀ°ÊÊ*i>ÃiÊVÌ>VÌÊÞÕÀÊV>Ê/ >ÃÊEÊ iÌÌÃÊÀi«ÀiÃiÌ>ÌÛiÊvÀÊÃÌÀÕVÌðÊ
SEL is a registered trademark of Schweitzer Engineering Laboratories, Inc.
POWER
MODULE
GROUND
CONTROL
SUPPLY
PT
LINE
NEUTRAL
GROUND
Line
Recloser
351R and 351R Falcon only;
Cable Plugs Directly into Recloser
on 351RS Kestrel and 651R
Utility
Pole
Recloser
Control
Protective
Shield around
Pole Ground
Control
Cable
System
Neutral
Pole
Ground
Arresters
Typical Installation Detail
