ThermoFlow Elex 18, Mounting And User Manual

Page: 17 / 28

DE GB
17
2. Mounting instructions
Contents
• 1 device (Hydrex/Elex 18, 21, 24kW)
• 1 mounting template
• 1 bag of installation materials, contents:
① 1 extended elbow with filter
② 1 nipple
③ 4 gaskets
④ 4 spacers
⑤ 4 plugs
⑥ 4 screws
Unpacking
Check if the device has been damaged in any way.
Environment
To prevent damage during transport this unit is supplied in robust packaging. Please recycle the
packaging where possible.
Disposal of the appliance
Old appliances must not be disposed of in your household waste!
Every consumer is legally obliged to dispose of old appliances separately from their household waste
and to take them, for example, to a collection point in their local community or lo-cal district. Old
electrical appliances will be accepted there free of charge. This ensures that the old appliances are
properly recycled and any negative impacts on the environment are avoided. This is why electrical
appliances are marked with the symbol shown on the left.
Tools
You will require the following tools for the installation:
• Cross-head screwdriver
• Open-ended spanners, 17 and 19mm
• Teflon tape
• Drill
• 8mm stone or concrete drilling bits
• Pencil
• Adhesive tape
• Wire strippers
This unit requires a 400V, three-phase supply. If the electrical installation does not meet these re-
quirements then it will need to be modified. This should be done by a qualified electrical installer, in
accordance with the relevant regulations (IEEE, etc.).
Preparing for installation
The water and electricity supply need to be available at the place where the device is to be supplied.
If the electricity cable is buried in the wall then use the supplied spacers. If the elec-tricity cable is
fixed to the wall then the device can also be fixed straight to the wall.
�
�
�
�
�
�