Thermo Scientific Thermo Scientific SL16, Instruction Manual

Page: 28 / 62

4
Operation
Entering parameters
4-4 SL 16 / 16R Thermo Scientific
Entering parameters
The Thermo Scientific SL16 offers you a total of 9 acceleration and 10 braking curves with which
samples and gradients can be centrifuged.
After the centrifuge is turned on, the last running profile selected is shown.
Acceleration curve
1. Press the key below the ACC display in order to open the acceleration profile selection
menu.
The display shows the message "Acceleration"
2. Select the profile by pressing the key, until the desired acceleration curve shows.
Braking profile
1. Press the key below the DEC display in order to open the braking profile selection menu.
The display shows the message "Set Deceleration“
2. Select the profile by pressing the key, until the desired deceleration curve shows.
Preselecting Speed / RCF
1. Press the key below the “SPEED” display.
The display shows the "RPM“ or the "RCF"-value depending on the display setting. Press the
key to toggle between the two values.
2. Enter the desired value by pressing the key repeatedly, until the desired value shows.
Note If an extremely low RCF value has been selected, it will be corrected automatically if the
resulting speed is less than 300 rpm.