4
Operation
Entering Parameters
28
Sorvall LYNX 4000 / 6000
Thermo Scientific
2. Place the rotor over the centrifuge spindle and let it slide slowly down the centrifuge spindle.
The rotor clicks automatically into place.
3. Check if the rotor is properly installed by lifting it slightly on the handle. If the rotor has not been
locked, place the rotor over the centrifuge spindle again.
4. Close the rotor with the rotor lid.
5. Close the centrifuge door.
Entering Parameters
Acceleration / Deceleration Profiles
There are 9 curves (1-9) for acceleration and 10 for deceleration(0-9). The acceleration / deceleration
profile can be selected in the main screen.
Figure 10.
Enter Acceleration and Deceleration Profile
Touch the desired field and a window will open.
Note
Do not force the rotor onto the centrifuge spindle.
If the rotor is very light, then it may be necessary to press it onto the centrifuge spindle with a bit of
pressure.
WARNING
If the rotor cannot be properly locked in place after several attempts, then the
Auto-Lock is defective and you are not permitted to operate the rotor.
Check for any damage to the rotor: Damaged rotors must not be used.
Note
Keep the centrifuge spindle area of the rotor clear of objects.
WARNING
Check that the rotor is properly locked on the centrifuge spindle before each
use by pulling it at its handle.
WARNING
Be sure to check all sealings before starting any aerosol-tight applications.
See the information in the rotor instruction manual.
Summary of Contents for Sorvall LYNX 4000
Page 18: ...1 Introduction and Description 8 Sorvall LYNX 4000 6000 Thermo Scientific ...
Page 28: ...2 Before Use 18 Sorvall LYNX 4000 6000 Thermo Scientific ...
Page 34: ...3 Control Panel 24 Sorvall LYNX 4000 6000 Thermo Scientific ...
Page 71: ...Thermo Scientific Sorvall LYNX 4000 6000 61 Index ...
