Thermo Scientific SHKE8000 Series, Maintenance Manual

Page: 11 / 106

1-2 Model SHKE8000 Series Shakers Thermo Scientific
Section 1
Installation
Warning Use extreme caution when lifting and positioning the stackable
shaker. Model SHKE8000/SHKE8000-ICE weighs 550 lbs. (249.5kg)
and Model SHKE8000-7/SHKE8000-8CE weighs 600 lbs. (272.2kg).
s
Warning Do not lift the unit by hand. Always use suitable equipment
designed to support over 600 lbs. (272.2kg).
s
Warning It is imperative that all specified installment hardware be used
when stacking shakers. Failure to do so may result in severe injury and/or
equipment damage.
s
Caution
Do not lift the unit under the sidecar! The sidecar structure is
not designed to support the weight of the unit.
s
Caution Do not lift or position the unit by the door or door handle.
Damage to door mounting and gasket may occur.
s
Caution Do not lift with forklift or other lifting device near the center of
the unit base. Damage to the shaker mechanism mounting may occur.
When lifting from the base, position the lifting device as close as possible
to the leveling feet. Whenever possible, lift the unit by the four threaded
inserts (Figure 1-3). Do not attempt to lift a stack of units by the
threaded inserts. The inserts are provided to lift and position only one
unit at a time.
s
Before stacking the shakers, make sure all units are turned off and
disconnected from the power source. To access the threaded inserts
needed to secure the shakers to the stand or another unit, remove the
front kick panel and back cover plate (Figures 1-2 and 1-3). Remove the
screws where indicated. Replace after stack is secure.
Positioning
Tabs
Remove this cover (7 screws)
Threaded
insert
Threaded
insert
(behind cover)
Figure 1-2. Kick Panel on Front of Unit
Figure 1-3. Cover Plate on Back of Unit