Thermo Scientific PrintMate AS, Operator'S Manual

Page: 28 / 87

PrintMate AS A83810100 Issue 2
20
Electrical Connections and Start-Up Procedure
Note
The following instructions assume that the LabWriter Application has been pre-installed. If this is not the case
refer to the LabWriter Operator Guide (A82810105) Chapter 1 - Installing the Software.
The PC and PrintMate should be connected as follows:

Set up the PC as described in the manufacturers’ instructions.

Position the instrument such that it is possible to interrupt the Mains supply at the source by removing the
plug from the socket.

Ensure the Power Switch on PrintMate is set to the Off (O) position.

Connect the Power Lead to the Power Connector and then plug it in to a suitably rated Mains Power
Supply.

The length of the Mains Cord should not be greater than 3m.

This instrument is supplied with power cables suitable for the UK, the USA, France and Germany. If an
alternative plug is required, a technically-competent person must remove the moulded plug and replace it
with a suitably rated, fused plug.

Power up the PC so that the Windows Desktop is shown.

Ensure the LabWriter Application is correctly installed onto the PC.
Do not run the LabWriter Application yet.

Turn on PrintMate and wait until the Touch Panel Display reads PrintMate Ready.

Connect the USB (Type A) Connector to the PC.