Thermo Scientific Lindberg/Blue M Mini-Mite TF55030, Installation And Operating Manual

Page: 39 / 68

| Main Controller: 1x8 & 5x16 Segment Programmable
6-37
|
304243H02
Mini-mite Tube Furnace
Chapter 6
End Type parameter
The action which occurs at the end of program or in reset depends on the configuration of
the
‘END.T’ parameter. The ‘END.T’ can be:
OFF : The heating is turned OFF,
dwEll : Controls at last program setpoint,
SP2 : Controls at setpoint 2 (When the timer completes the target setpoint will switch to
setpoint 2. The setpoint 2 may be a lower or a higher temperature.),
rES : Reset on completion and reverts to SP1 or SP2, based on the Setpoint selection.
SCROLL through parameters in level 2 and set the required ‘END.T’ by pressing
or .
OR OR OR
To Configure the Programmer
1. Enter level 2 to configure the timer as a programmer. Press SCROLL button to
scroll through the list of parameters until ‘TM.CFG’ is displayed. Now, press
DOWN or UP button to select ‘PROG’ .
2. To set the resolution, press SCROLL button to select ‘TM.RES’ . Press DOWN
or UP button to set ‘Hour or ‘min’ (In this example, the ramp rate and dwell
period are set in hours).