Thermo Scientific Barnstead Smart2Pure 12 UF, Operating Instructions Manual

Page: 63 / 110

10
Initial start up
Thermo Scientific Smart2Pure
53
• Put in the voltage supply from the power pack into the power supply from the system on
the connection panel.
• Wait until the tank filling has been completed. This could take approx. 1.5 to 3 hours
with a Smart2Pure 3/6 system. With a Smart2Pure 12 system this could take up to 2.5
hours to fill a 30L tank and about 5 hours to fill a 60L tank. Discard the content of first
tank filling.
• Before screw in the sterile filter onto the dispensing valve outlet, wait until the tank have
the maximum capacity and leave approx 2-run 3 liters pure water from the dispensing
valve.
• Screw in the sterile filter.
• After connecting the power supply into the system, a brief self test is starting for
approx 5 minutes. After the brief self test the system begins to produce pure and
ultrapure water.
• If the tank content of the Smart2Pure 3/6 system is empty it is possible that air is
coming from the tank into the ultrafilter (only systems with ultrafilter). Thereby
you can not dispense water from the sampling tap on the system. Proceed as
follows in such a case:
• unplug the main plug and wait 5 seconds before you put the main plug
back.
• Wait approx 10-15 minutes before you start with dispensing water from
the sampling tap.