e) Connecting and disconnecting from to power source
e) Connecting and disconnecting from to power source
The user should hold the plug to remove from power source. When
connecting the plug, user should make sure it has been fully plugged in;
when removing the plug, do not pull the power line forcefully.
f) Placement of the instrument
f) Placement of the instrument
This instrument should be fixed in a low RH and low dust place away
from water source (e.g. sink or water pipeline) and the room should be
well ventilated, and free of corrosive gas or interference of strong magnetic
field. The instrument should not be placed in a wet or dusty location.
The openings on this instrument are for ventilation circulation and in
order to avoid over-heat of the instrument body they should not be
blocked or covered. When a single set of instrument is used, the interval
between ventilation opening before and after the instrument and its nearest
object should not be less than 25cm. Also, don’t use the instrument on
loose or soft surface, or the air inlet of instrument bottom might be
blocked. Excessive temperature will impair performance or result in failure
of instrument. This instrument should not be used in location subjected to
direct sun light. The instrument should be kept away from hot gas, oven
and all other heat sources. If the instrument is to be stored for a long time,
the power plug should be withdrawn and the instrument covered with soft
The product is powered by connecting the mains plug to a standard
socket-outlet.Always place the product in such a way that it is easy for the
operator to disconnect the product from the mains supply.
cloth or plastic film to avoid entrance of dust.
1-2Drybath Incubator
Thermo Scientific
