Drybath Incub 1-1
Thermo Scientific
During operation, maintenance and repair of this instrument, the
following basic safety notes should be observed. In case of failure to follow
these instructions, the warnings or notes indicated herein, the basic
protection provided by the instrument, its safety criteria of design and
manufacture, and its predicted use range would be impaired.
If the
equipment is used in a manner not specified bythe manufacturer, the
protection provided by the equipment may be impaired.
Thermo Fisher Scientific is not responsible for any injury as a result of the
user’s failure to observe the following requirements.
This instrument is for indoor use.
a) The ground connection
a) The ground connection
To avoid the electric shock, the input power line must be reliably
grounded. The instrument is equipped with the three-pin plug that has the
third pin (the pin connects the ground), therefore, the plug should be used
with the grounded power socket only. This is a kind of safety device. If the
plug cannot be plugged into the power socket, please ask the electrician to
install a correct power socket, so as to make the grounded plug to work for
safety.
b) Servicing and Replacement of Parts
The operator should not take apart the instrument without permission.
Only qualified professionals are allowed to replace elements or adjust
components inside the instrument. Replacement of components while unit
is connected to power and/or turned on is prohibited.
c) Observe voltage/power requirements
c) Observe voltage/power requirements
Before the instrument is connected with the AC power source, the voltage
of the power source should be the same with the required voltage of the
instrument (a deviation of 10% is allowed). The rated load of the power
socket should not be lower than the requirements of the instrument.
d) The power cord
The instrument should use the power line cord attached to it. If the
power line is destroyed, it must be replaced but not be repaired. The
replacement should be carried out with the power line of the same type
and same specification. No items should be put on the power cord when
the instrument is in operation.
b) Servicing and Replacement of Parts
d) The power cord
