This procedure is for 4x16 Segment Programmable Models only.
1. Press the PAGE button until you reach the program list (ProG LiSt).
2. Press the SCROLL button until display reads, “tGt.”
3. Press the UP or DOWN button to set the target setpoint temperature.
8 Segment Programmable Models only
To run a program, press the RUN/HOLD button (the RUN light will
illuminate).
4x16 Segment Programmable Models only
To run a program, press the RUN/HOLD button (the RUN light will
illuminate).
or:
1. Press the PAGE button until you reach the run list (run LiSt).
2. Press the SCROLL button until display reads, “PrG.”
3. Press the UP or DOWN button to select the program number you
want to run.
4. Press the RUN/HOLD button once to start the program. (The RUN
light will illuminate.)
To put a running program on hold, press the RUN/HOLD button. (The
HOLD light will illuminate.)
To cancel a program, hold the RUN/HOLD button down until the RUN
and HOLD lights go off.
Clean Room Oven
6-13
Thermo Scientific
Section 6
Programmable Models
Setting the Target
Setpoint
Running a Program
Holding a Program
Cancelling a Program
