Home Display
°C
: measured temperature in Celsius. Temperature units can not be
changed without entering the configuration. Contact Technical
Services if a different temperature unit is required.
OP
: % output power demand; displayed in lower display (cannot be
changed).
C.id
: Controller identification number.
PrG
: Program number (displayed when a program is running; 4x16
programmable models only.)
IdHi
: Deviation High Alarm
tunE
: One-shot autotune enable.
run LiSt (Program Run List)
PrG
: Currently running program (only used on 4x16 programmable
models)
StAt
: Displays the program status [OFF, run (running active program),
hoLd (program on hold), HbAc (waiting for process to catch up),
End (program completed)] in the lower display. The controller will
default to “OFF.”
FASt
: Fast run through program (no/YES). The controller will default
to “no.”
SEG.d
: Flash active segment type in the lower display of the home
display (no/YES). The controller will default to “no.”
ProG LiSt (Program Edit List)
PrG.n
: Press the UP or DOWN ARROW to select the program
number (program number will be displayed in lower display on
4x16 programmable models only.)
Hb
: Press the UP or DOWN ARROW to select the holdback type
[OFF (disables holdback), Lo (deviation low holdback), Hi
(deviation high holdback) or bAnd (deviation band holdback)] for
the entire program. The controller will default to “OFF.”
6-4
Clean Room Oven
Thermo Scientific
Section 6
Programmable Models
Controller Parameters