9-4
Nanopure™ Analytical
Thermo Scientific
Section 9
User Settings
Use of Standby Mode
At the end of the work day, place the Nanopure Analytical in Standby
mode for the night. To place the unit in Standby mode:
1. From the (Idle) mode, when display reads, “Nanopure (Idle) xx:xx:xx
xx/xx/xx,” press STANDBY.
—OR—
2. From the xx.x M
Ω
-cm or x.xx uS/cm operational display, Press
STANDBY.
After STANDBY is pressed, the display will read “Standby” and the green
LED will slowly blink. For 10 minutes of every hour while the pump is
energized, the display will read “Standby (Recirculating) xx minutes.” Press
START/STOP to return to the recirculating mode.
Note
When in Standby mode, press START/STOP to continue normal
operation.
s
Note
Refer to Auto Standby section to have the unit automatically enter
Standby Mode each day at a predetermined time chosen by the user.
s
Note
If you have installed an Accudispense volumetric remote dispenser, its
“Purity Above Setpoint” LED will slowly blink when the water system is in
Standby Mode.
s
The Nanopure Analytical electronics include a user programmable set
point which alerts you when water quality falls below the programmed set
point. The set point is user selectable from 1-18 M
Ω
-cm (factory set at 10
M
Ω
-cm.).
1. From the (Idle) mode, when display reads, “Nanopure (Idle) xx:xx:xx
xx/xx/xx,” press the UP or DOWN arrow until display reads,
“Advanced Menu?”
2. Press ENTER.
3. Proceed through the options by pressing ENTER until “Adjust Set
Point” is displayed.
4. Press the UP or DOWN arrow to choose “Yes.”
5. Press ENTER.
6. Press the UP or DOWN arrow until the desired value is displayed.
7. Press ENTER.
Selecting the Set
Point
