Section 6
Controls
The main power switch on the Nanopure Analytical is located on the
lower back right side of the unit (as you face the front of the unit), directly
above the power cord receptacle.
The Nanopure Analytical is controlled through a panel which incorporates
switches to control its functions: START/STOP, STANDBY, DISPENSE,
DOWN, UP, ENTER and BACK. This control panel utilizes a digital
display to show system information and the purity of the product water.
The intensity (brightness) of the display may be adjusted according to user
preference. See “Adjusting Display Brightness” in “User Settings” of this
manual.
A single LED located on the top of the control panel will illuminate to
inform you of the system status as follows:
• LED is not illuminated: System is OFF or in (Idle) mode.
• Solid Green LED: System is recirculating and operating normally.
• Blinking Green LED: System is in Standby mode.
• Red LED: System is alerting user to an operational error or
maintenance issue.
Nanopure™ Analytical 6-1
Thermo Scientific
STANDBY
START
STOP
DISPENSE
NANOpure DIamond
NANOpure DIamond
™
BACK
ENTER
LED
Figure 6-1.
Control Panel
Main Power Switch
Control Panel
