Thermo Scientific 10519, Instruction Manual

Page: 15 / 44

Chapter 2 Installation
2-3
STARTUP PROCEDURE
1. Connect the power cord to the rear of the unit and turn the power ON.
2. Check to make sure the power switch light is ON.
3. Monitor the indicator lights. Switch the selector switch from various positions to check
if all the LEDs are turning ON properly.
4. While moving the switch, listen for the solenoid valves to click into position and observe
that the appropriate LEDs turn ON in turn.
The Model 200L Single Dilution Probe Controller is now ready to be installed either in a
rack assembly or for test bench purposes. With the unit placed in a secured location, the
lines to the unit can be connected. Figure 2-3 illustrates a common connection to a rack
system for a Model 200L Single Dilution Probe Controller. Four major plumbing
connection lines, and the system plumbing configuration, are critical to the operation of the
controller. The four major plumbing lines are Diluted Air (DA), Diluted Sample (DS),
Vacuum Line (VL), and Calibration Line (CL).
Figure 2-3. Typical Single Probe Controller System Line Connections