Chapter 4 – Using the Instrument
Parameter
Function
Smoothing
Selects the degree of smoothing required at run
time.*
UV
calc
Refer to “Using UV
calc
”.
*
Alternatively, these operations are all available as post-run manipulations.
3.
Set up any Accessory Methods required (only when a Smart
Accessory is installed).
4.
Save method.
To save the method to the instrument Library or disk, press the Save
Method function key and follow the on-screen instructions.
5.
Load a method from the instrument Library or from disk.
To do this, press the Load Method function key or press Library.
6.
Remove any unwanted samples from sample compartment.
7.
Insert a suitable reference, if required, and close the lid of the
sample compartment.
8.
Press Zero to measure a baseline.
9.
Open lid of the sample compartment and insert the sample and
then close the lid.
10.
Press Run.
The Scan Graph page will appear.
38
Evolution 300 and Evolution 600 User’s Guide
Thermo Electron Corporation
