VOLTMAX ELECTRIC BOILER Installation and Operation Manual
(
Revised June 2017)
, Page
44.
This menu’s configuration options
are presented
in detail in
Section 4.11
.
4.3.7 ALARM
Alarm Mode Configuration
When an alarm is active, it will be displayed on
the main display as a symbol.
An alarm is active
The boiler is in lock mode
HL
The high limit temperature has been
reached
LL
Low limit (Lack of capacity)
P
Pressure problem alarm
A
Electrical problem alarm
F
Flow problem alarm
Se
Sensor problem alarm
Ex: If P and Se are displayed at the same time,
this indicates a pressure sensor problem
A summary of active alarms is also available in
the
Boiler status
menu.
An alarm report is available under the
Alarm log
menu. Information about date, time and alarm
code is available in this menu. The internal clock
must be adjusted beforehand so that the alarm
registers
correctly.
Section
6
-
Troubleshooting
details alarm codes and
settings specific to this menu.
Details about this menu’s operation are available
in Section 4.12
4.3.8 COMMUNICATION
The boiler controller can be connected via an
Ethernet network communication port or using a
BACNet protocol. The boiler web portal can be
accessed in a variety of ways. You will be able
to modify the parameters remotely on a web
portal and to visualize the anomalies.
Direct connection between the controller and
a computer.
1. Connect the boiler controller to your local
network or directly to your computer in an
internet port using an RJ45 network cable
(located on the back of the controller). Refer
to the wiring diagram, if you have any
questions.
2. Open the
Network and sharing center
,
then
Change adapter setting
on a windows
operating system. Open the
Local area
connection
properties,
then
Internet
Protocole Version 4 (TCP/IPv4).
3. Replace the parameters by those show on
the following figure.
4. Open a web browser and enter the IP
address (available in the Communication
menu / Ethernet) of the controller in the web
address bar.
5. Enter your username and password.
Default
Address IP
10.0.0.100
User
Administrator
Password
password
