DOC NO. 81078
Page 16 of 18
Rev D 3/06 GM
OneTouch/Elite Combination Operation Instructions
Warning: Please consult your physician before using. If you are pregnant, elderly, have high
blood pressure, diabetes, suffering from heart disease, intoxicated, or not in good health, do not
use this steam bath.
1. The Elite control functions will remain the same but the
OneTouch acts ONLY as an on/off switch
.
Refer to the Elite operation instructions, which are included with the control.
2. When the OneTouch is turned on, it sends a signal to the Elite turning it on and loading the last time
and temperature settings.
3. When the Elite is turned on, it will operate like normal but will send a signal to the OneTouch turning it
on and display the current time setting.
Powerflushing Your Steam Generator
1. Power on the control and set the timer to 45 minutes. Open the powerflush ball valve located on top
of the generator (refer to Figure 1) for 5-7 minutes, then close. Allow generator to finish the 45-minute
session. See following document for more detail about powerflushing.
** ThermaSol recommends one powerflush cycle after every fifty uses. **
Warning: IT IS IMPORTANT THAT NO ONE BE INSIDE THE SHOWER ENCLOSURE
DURING THE POWERFLUSH CLEANING CYCLE. IT IS ALSO IMPORTANT THAT THE
ENCLOSURE DOOR BE CLOSED DURING THIS CYCLE.
Warning: Exit shower area once the powerflush is started, hot water from Steamhead can burn
you. Keep the steam door on the enclosure closed during this cycle.
Headquarters & Technical Support
2255 Union Place, Simi Valley, CA 93065 – (800) 776-0711
Mon – Thur 7:00 – 5:00, Fri 8:00 – 12:00 PST
Eastern Sales Office
26 Industrial Avenue, Fairview, NJ 07022 – (800) 631-1601
Mon – Thur 7:00 – 5:00, Fri 8:00 – 12:00 EST
www.thermasol.com
Note: Actual remote graphics may differ.
