English 16
Step 7: Backguard Installation
(optional)
Installation methods will vary upon need. Before you begin
read these instructions carefully. Observe all local codes
and ordinances.
Backsplash Installation
(PA [
30, 36, 48
] JBS)
The Backsplash must be installed prior to installing an
overhead hood given that the hood shell covers the top
mounting screws of the Backsplash.
To protect against scratches, leave protective film on
Backsplash until after installation is complete.
If range is already installed, refer to the manufacturer’s
instructions to disconnect gas and power supplies. Move
range forward to gain access to rear of unit.
1.
Locate and lightly mark wall studs. Wall studs are
usually installed with a 16” or 24” (406 or 610 mm)
space on center.
2.
The height of the hood will determine the height of the
top edge of the Backsplash. The Backsplash should be
mounted so that the bottom rear edge of the hood
overlaps the Backsplash 1
½
” (38 mm).
3.
Per each wall stud, use (2) 1” (25.4 mm) Phillips head
screws to secure both the top and bottom of the
Backsplash (see
Figure 11
). Space screws evenly
across top and bottom of Backsplash.
•
Due to variable wall stud widths and varying
Backsplash widths, in some cases only one wall
stud may be found at the mounting location.
4.
Remove protective plastic.
Model
6" Std.
Low Back
9" Low Back
22" High Shelf
3" Flush Island Trim
30”
PA30GLBH
N/A
PA30GHSH
Included with range
36”
N/A
PA36GLBH
PA36GHSH
Included with range
48”
N/A
PA48GLBH
PA48GHSH
Included with range
Table 4: Backguard Kit Model Numbers
Parts Included
Tools Needed
10 – 1” (25.4 mm)
screws
Phillips screwdriver or
drill
1 – Backsplash
Tape measure
1 – Installation Guide
Pencil
WARNING:
To reduce the risk of fire or injury to persons, check to
make sure all packaging has been removed from
accessory devices before use.
Figure 11: Backsplash Installation
www
NN
w
NN
Summary of Contents for Professional Pro Harmony PRG304GH
Page 2: ......
