11
Operating the Dishwasher
Start the dishwasher:
1
Open the door and press the
ON/OFF
button.
2
Select a cycle and desired options.
3
Close the door to begin the cycle.
Delay start:
1
Open the door and press the
ON/OFF
button. Select a cycle.
2
Press and hold the
Delay start
button. Release when the desired delay time is shown in the display window.
3
Close the door to begin the cycle.
Cancel a cycle:
1
Open the dishwasher door just far enough to expose the control panel. Be careful of hot water that may splash out.
2
Press and hold the two buttons labeled
CANCEL/RESET
for 3 seconds.
3
Close the door and wait about 1 minute while the dishwasher drains.
4
Open the door and press the
ON/OFF
button. You may now start a new cycle.
WARNING
You could be seriously scalded if you allow hot water to splash out of the dishwasher. OPEN THE DOOR CAREFULLY
during any wash or rinse cycle. Do not fully open the door until water noises have stopped.
Interrupt a cycle:
1
Open the dishwasher door just far enough to expose the control panel. Be careful of hot water that may splash out.
2
Press the
ON/OFF
button to turn the unit off.
3
Wait at least 10 seconds before fully opening the dishwasher door.
4
To resume the cycle, press the
ON/OFF
button and close the dishwasher door.
Added heat for drying:
1
Press and hold the
Auto
button, then press and hold the
ON/OFF
button.
2
When the LED display window indicates a “0” or “1” release both buttons.
3
To activate the added heat for drying, press the
Auto
button until the display indicates “1”.
4
To disable the added heat for drying, press the
Auto
button until the display indicates “0”.
5
Press the
ON/OFF
button to save the setting.
Cycle completion signal:
The cycle completion signal alerts you when a cycle completes and the dishwasher has washed and dried the dishes. You
can choose to disable the tone or adjust the volume. The dishwasher must be powered OFF before adjusting the signal.
To activate:
1
With the unit OFF, press and hold the right of the two
CANCEL/RESET
buttons and then press and hold the
ON/OFF
button.
2
When the light on the
CANCEL/RESET
button you are pressing illuminates and the tone goes off, release both buttons.
3
Press the right of the two
CANCEL/RESET
buttons again until you achieve the desired volume or until there is no tone
(to turn cycle completion signal OFF).
4
Press the
ON/OFF
button to save the setting.
Summary of Contents for Emerald DWHD410JFM
