Page 9 of 15
1.25hp and 1.75hp TVS VARIABLE 3 SPEED OPERATION
The TVS Pro Variable Speed Pumps has 3 speed settings….
1.
Eco (Energy Saving)
This should be used for everyday water filtration
The pump should be operated for approximately 8 hours per day depending on the
surrounding climate, bather loads, pool volume and length of pipework.
In some cases when your pool has areas where water is not turning over, increase the
speed setting
This setting is
not
recommended to be used with a suction cleaner but may work.
2.
Med
This should be used for gentle spa jet action and the majority of suction cleaners when
connected to a skimmer box
3.
High
This should be used for backwashing, manual vacuuming of the pool, operating gentle or
soft spa jets and/or water features.
PLEASE NOTE
The TVS Pro will always run at “high” speed for 3 minutes upon start up or a filter
cycle. This assists with priming of the pump and pipe work.
After the initial 3 minutes the TVS Pro will revert back to the previous selected speed
it was set at before it was turned off.
Priming function can be disable, however, this is not recommended
CHANGING PRIME ON/OFF, PRIME DURATION AND PRIME SPEED
Turning Prime On / Off
o
Press the stop button 3 times simultaneously
o
Screen should read “P off”
o
Do this again to turn it on, “P on”
o
Disabling Prime function is not recommended for standard operation use
Changing Prime Duration
o
Hold Off button for 10sec
o
Screen with display P 3 -- Depicting 3 Minutes
This can be increase up to 120 minutes
Press set to save 3 times
Changing Prime Speed
o
Hold Off button for 10sec
o
Screen with display P 3 -- Depicting 3 Minutes
o
Change Prime Duration if required (See above)
Press Set -- P 3
Screen will display 2850 (Highest possible speed)
Increase or decrease as desired by using up and down arrows
Press set to save 2 times
