Themis RES-22XR3, Installation Manual

Page: 107 / 162

3-37
Themis Computer
3—BIOS Setup Utility
BIOS Recovery
2. Make sure that the new BIOS Image file is accessible for the host system.
3. Start the terminal program on the host system and create a new connection.
4. Use the following communication parameters for the new connection.
• Bits per second: 115200 bits/sec.
• Data Bits: 8
• Parity: None
• Stop Bit: 1
• Flow Control: None
5. Power on your system and click the <Connect> button in the Hyper Terminal.
The terminal screen will display the following messages.
................. Press <SpaceBar> to update BIOS.
..................... Confirm update BIOS? (y/n) y
................. Begin remote BIOS flash? (y/n) y
............................ Starting remote flash
...... Upload new BIOS file using Xmodem protocol.
6. Following the instructions given on the screen to update the BIOS. These
instructions are also shown below.
a. At the prompt, press the <SpaceBar> to update the BIOS.
b. When asked to confirm BIOS updating, press <y> to confirm BIOS up-
dates.
c. Press <y> again to begin flashing BIOS remotely.
.
7. Once you've completed the instructions given, a screen will display to indicate
that remote flashing is starting and the new BIOS file is being uploaded.
Note: Be sure to complete Steps a to c above quickly because you have a second
or less to do so.