Themis 2P2 PMC, User Manual

Page: 11 / 126

viii
Themis Computer
PMC/XMC Carrier Board Manual
Figure 2-16 2P2 PMC/XMC Carrier Board Component and Connector Diagram ........... 2-34
Figure 3-1 2P3 PMC Carrier Board................................................................................... 3-1
Figure 3-2 2P3 PMC Carrier Board Block Diagram ......................................................... 3-2
Figure 3-3 2P3 PMC Carrier Board VME P1 Connector Orientation............................... 3-4
Figure 3-4 2P3 PMC Board VME P2 Connector Pin Orientation..................................... 3-6
Figure 3-5 2P3 PMC Module Slot Connector Pin Orientation.......................................... 3-8
Figure 3-6 2P3 PMC Carrier Board Solder-Bead Locations (Bottom Side) ................... 3-19
Figure 3-7 2P3 PMC Carrier Board Front Panel ............................................................. 3-22
Figure 3-8 2P3 PMC Carrier Board Component and Connector Diagram...................... 3-23
Figure A-1 Seven Screw Locations ................................................................................... A-2
Figure A-2 Remove 3 Screws Securing Injector/Ejector Handles .................................... A-3
Figure A-3 Hold the Baseboard Down Against Work Surface ......................................... A-4
Figure A-4 Use Fingers to Apply Upward Pressure.......................................................... A-4
Figure A-5 Separated Baseboard and PMC Carrier Board ............................................... A-5
Figure A-6 Align Three Tabs to Slots ............................................................................... A-6
Figure A-7 Expected Gap is Approximately 1/8” ............................................................. A-7
Figure A-8 Press Down on the PMC Interface Standoffs ................................................. A-8
Figure A-9 Use Interposer Material if PMC Interface Standoffs Don’t Exist .................. A-8
Figure A-10 Loctite 222MS ................................................................................................ A-9
Figure A-11 Apply Loctite to End of Screw ....................................................................... A-9
Figure A-12 Only the Last Few Threads Need Loctite ....................................................... A-9
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com