Blinds and switch actuator RMG 8, blinds actuator JMG 4
and switch actuator module RME 8 - EIB
theben
As of: Apr-06 (Subject to change without notice)
Page 21 of 36
Table 1-5: continued
Designation
Values
Description
How many impulses
can be added max.
1 ... 40
Keyboard input 1 to 40
A summing function enables the
user to extend the programmed
staircase lighting time by multiples
by repeatedly actuating the light
switch.
Actuating it twice = double time.
Here you can set, how many of
these repetitions are to be
permissible.
It is possible at any time to start the
extension sequence all over.
Parameters for the impulse function
Time base for impulse
width
1 sec, 10 sec, 30 sec, 1 min
A 1 sent to the object initiates an
impulse.
The length of the impulse is
composed of a time base and a
factor (refer to the description of
the parameters for the staircase time
switch)
Factor for impulse
width
1 ... 255 x Time base
Keyboard input 1 to 255
The impulse width is equal to the
time base multiplied by the factor.
Example:
Time base 10 s x factor 2 is
2 x 10 s = 20 s
Parameters for ON/OFF delay
Time base for ON and
OFF delay
1 sec, 10 sec, 30 sec, 1 min
The two delay times (ON and OFF)
can be defined separately but
reference the same time base.
Factor for ON-delay
Keyboard input 1 to 255
Due to the separate factors, the
delay time can be set individually
for the OFF and for the ON delay.
Example:
Time base 10 s x factor 2 is
2 x 10 s = 20 s
Factor for OFF-delay
Keyboard input 1 to 255
Example:
Time base 10 s x factor 2 is
2 x 10 s = 20 s
* In typical applications, the behaviour after a recovery of the bus voltage is set identical to the behaviour after a
recovery of the mains voltage without bus voltage.
**staircase timer and impulse only
