10/2021 V 1.1
VIEW 06
Trim the flaps
Notch
Tray
Cut
Cut
15/17
Check the Glass to Wall Seal orienta�on
and trim a notch to fit around the
Bo�om Door Seal.
With a sharp modelling knife, cut the
Glass to Wall Seal tail above and below
the 90° Glass to Wall Hinges as shown.
Take care to get these cuts as close to
the hinges as possible to allow the Seal
to flex around the Hinge without
leaking.
Push both Ver�cal Seals down as far as
they can go.
With a straight edge, mark where the
Seals will be trimmed. Remove the
Seals and trim with a fine toothed
junior hacksaw so they are flush with
the tops of the Glass Panels.
Replace the seals.
A�ach the Handle if included. Secure in
place with the grub screws provided.
The Handle should be oriented so that
the grub screws are not visible when
looking down on the handle.
40
41
42
43
