10/2021 V 1.1
VIEW 06
04/17
Remove and replace the Panel adding
or subtrac�ng spacers as necessary to
level the Panel (to a maximum height
of 5mm inside the Underframe).
Check the Panel is level using a Spirit
Level.
Check the Return Panel has a 4mm gap
between the Panel and the front face
of the Front Underframe.
If the Wall Profile is flush with the Glass
Panel, move on to step 17.
If the Wall Profile is not flush with the
top of the Glass Panel, mark the Wall
Profile. Using a straight edge, mark
where the wall channel needs to be
trimmed.
To protect the channel finish, it is
recommended to mark on masking
tape.
Remove the Panel, Wall Profile So�
Seal, and the Wall Profile.
Trim the Wall Profile.
Use a fine file to remove any burrs. Be
careful not to damage the channel
finish.
Re drill the screws in to the Wall Profile
and remove a�er drilling.
Reinstall the Wall Profile and Wall
Profile So� Seal.
13
14
15
16
4mm
