10/2021 V 1.1
VIEW 06
Flush
Outside of
enclosure
14/17
Li� the Door out and safely put to one
side.
Use the supplied Marking Template to
locate Hole “B”.
Use masking tape on the wall to mark
the measurements.
Using a Ø6mm high quality drill bit for
a clean and precise hole, drill all holes
and fully insert the wall plugs.
Ensure the Door Supports are s�ll in
place.
Carefully li� the door back into posi�on
and securely a�ach the Hinges to the
wall.
Make sure the screws are flush with
the bracket face.
Measure the width of the Door and
trim the Bo�om Door Seal accordingly
with a fine toothed junior hacksaw.
A�ach the Seal ensuring the Seal is
correctly oriented.
Professional Tip
If drilling ceramic tiles, place
masking tape on the tiles before
marking and drill through the
tape to prevent the drill bit from
skidding.
DO NOT use Hammer Action as
this will break the tiles.
36
37
38
39
