TROUBLE SHOOTING
PROBLEM
PROBABLE CAUSE
REMEDY SUGGESTED
Fails to split logs
Log is improperly positioned
Refer to “Operation” section for
perfect
log loading.
The sizes or hardness of the log
exceeds the capacity of the
machine
Reduce the log sizes before splitting it on
the log splitter.
Wedge cutting edge is blunt
Refer to “Sharpening Wedge” section to
sharpen the cutting edge.
Oil leaks
Locate leak(s) and contact the dealer.
Unauthorised adjustment was
made on Max. Pressure Limiting
Screw. Lower max pressure rating
was set.
Contact an approved service dealer.
The log pusher moves
jerkily, making
unfamiliar noise or
excessive vibration
Lack of hydraulic oil and
excessive air in the hydraulic
system.
Check oil level for possible oil refilling.
Contact an approved service dealer.
Excessive air in the hydraulic
system.
Purge the hydraulic system.
Remove the air bleed screw. Operate the
ram 5 or 6 times without a log in place.
Return the bleed screw to open position
and split the log. If the problem continues
contact the local approved service dealer.
Motor running, ram not
moving
Incorrect specification extension
lead
Be sure the extension lead is no longer
than 10m and its cross-section is no less
than 2.5mm² to allow enough current flow
to the motor.
Oil leaks around the
cylinder ram or from
other points.
Air sealed in the hydraulic system
while operating.
Loosen the Bleed Screw by 2 or 3 rotations
to open position, do not remove, before
operating the logsplitter
Bleed Screw was not tightened
before moving the log splitter.
Tighten the Bleed Screw fully after use and
before moving.
The Oil Drain Bolt with Dipstick is
not tight.
Tighten the Oil Drain Bolt with Dipstick
with 8mm Allen Key.
The Hydraulic Control Valve
Assembly and / or seal(s) are worn
Contact the local Approved Dealer
MAINTENANCE & STORAGE
Always ensure the Bleed Screw is fully tightened when the machine is not in use.
When not in use, the machine should be stored in a dry location. Keep away from direct sunlight.
Keep the machine away from children and others not qualified to use it. Avoid direct sunlight.
Do not store anything above or near the machine, where anyone might stand on the machine to reach them.
