RAM ADJUSTMENT
The logsplitter is fitted with a Ram Adjustment Knob which reduces any unnecessary movement of the ram,
allowing for quicker and more efficient use of the tool.
WARNING
When adjusting the ram movement, do not put your hands between the hand knob and the log splitter
mechanism, as accidental release of the Control Handle would cause the returning hand knob and handle to
trap and crush your hand against the splitter.
•
To adjust the ram movement, first undo the hand knob.
•
Then without a log on the work table depress the Control Handle and the start button.
•
When the gap between the ram and the splitting wedge is the intended size, release the start button, but
continue to hold the Control Handle to keep the ram in place.
•
Slide the hand knob along the pipe to set the gap size. The closer you move the Ram Adjustment Knob
towards the log splitter, and the more you slide it down the pipe, the smaller the gap will be left between
the ram and the splitting wedge.
•
If the gap is correct you should place the hand knob against the log splitter.
•
If the gap is too small you can leave an equivalent space between the knob and the log splitter so that the
ram returns further back.
•
If the gap is too small, you will have to press the start button to reduce it before setting the Ram
Adjustment Knob.
•
Once you have set the hand knob at the desired position,
retighten it to adjust the movement of the ram.
•
Make sure that your hand is clear of the hand knob area.
You can now release the Control Handle. The ram should
now return to the desired position whenever you release
the start button and Control Handle. You can repeat
these steps if further adjustment is required.
Ram
Adjustment
Knob
