THE GILBERT HALL American Flyer, Operating And Assembly Instructions Manual

Page: 52 / 66

HOOK UP OF NO.
771
TO A TRANSFORMER
Connect
BLACK WIRE
from Stock Yard to
BASE POST
on
Connect
RED WIRE
from Stock Pard to wire clip under the red button
Connect
YELLOW WIRE
from Stock Yard to remaining spring clip
Connect
YELLOW WIRE
from Control
Box to
15 VOLT
POST on
transformer.
on Control
Box.
on Control
Box.
Transformer.
OPERATING INSTRUCTIONS
Place the steers in the corral
-
4
on each side, then turn on the rotary
switch on the Control
Box.
This will cause the floor mat to vibrate and tho
steers will then mill around the corral and they can be left to mill continuously.
RAMP INSTRUCTIONS
The ramp on which the cattle travel to go into the car is movable up and
down. It should always be raised into the
up
position when not being used. If
left down the cars will strike it as they pass. Therefore, to load or unload the
car, stop the train at the stock yard and position the stock car so one of the
doors line up with the ramp. Then lower the ramp to the door entrance. After
car is loaded, raise the ramp before starting the train.
51