Figure 3
Figure 4
Setup and Installation
STEP 6 IS FOR THE TWIN XL, FULL,
QUEEN SIZES ONLY. Skip to Step 7 if
assembling King and you have already finished
page 3 King special instructions.
See Figure 4 for Step 6
Secure base stability by locking hinge joints on bed
frame using (1) bolt, (1) flat washer, (1) lock washer, and
(1) nut for each hinge joint as shown. Ensure that ALL
nuts and bolts on hinge joints are tight.
IMPORTANT: Twin XL has 2 hinge joints. Full and
Queen have 3 hinge joints.
With the help of your able-bodied assistant,
carefully lift the bed frame and set it upright on
its legs. Excessive lateral pressure may damage
the legs. Remove all plastic protective coverings.
NOTE: Make sure to clear all power cords so that they
do not interfere with any mechanisms of the adjustable
bed. Dispose of plastic protective coverings to
avoid injury.
Locate the (A) Wireless Remote and insert 3
AAA batteries (included).
Plug (D) Power Cord into a grounded electrical
outlet. Using (A) Wireless Remote, push the
HEAD UP button, FOOT UP button, and any
massage button for a momentary test of the
remote. If the adjustable bed responds to the remote,
skip to Step 11.
See Figure 5 for Step 10
If the adjustable bed does not respond to the
remote, synchronize (A) Wireless Remote with
(B) Control Box. Follow the steps below.
(1) Press and hold the HEAD DOWN and FOOT UP
buttons simultaneously on the remote.
(2) While holding down the buttons on the remote,
press EITHER the blue reset button on the side of the
control box OR the control box extension cord.
(3) You should hear a few quick beeping sounds
signaling that the remote is synced to the base. Test this
by pressing any button on the remote.
NOTE:
The RESET button can be used for emergency
flattening of the adjustable bed. Pressing the RESET
button levels the bed.
2
Figure 5
FIGURE BELOW IS FOR KING SIZE ONLY
6
7
8
9
10
1
2
3
4
RESET BUTTONS
RESET BUTTONS
