IOM CRUZcontrol®
P/N: 90480009
Revision Date: 03/18/2019
Page
15
of
58
Some things to consider regarding the use of these power supplies:
100-250 VAC input Power Supply:
•
The output voltage, while rated at 27 VDC, is suitable for use with CRUZcontrol.
•
A T Cable is provided with the Power Supply Kit for connection to the Power Supply output
terminals.
•
There are two sets of output terminals. These are connected in parallel, and provided only as a
convenience for the connection of two separate output cables. The T Cable can be connected to
either of these sets of terminals.
•
The Release In terminals, when provided with a voltage input signal, will put out a 24 VDC level
signal which can be used to enable (provide power to) either the Logic Signal or Slug Signal lines
of CRUZcontrol. The Release Out switch should be set to Sourcing. (The Release Out feature
is not required to operate CRUZcontrol. These same functions are also provided for with the
Function Module, which comes with plug in connections.)
•
The Power Monitor contact output provides a contact closure indication of 24 VDC power output
being on. This is not required to operate CRUZcontrol.
342-528 VAC 3 phase input Power Supply:
•
This power supply can be connected into the motor wiring for the conveyor, eliminating the need
to run a separate power feed to the power supply. The connections should be made at the output
terminals of the motor safety switch (disconnect switch). The effect of the power supply load on
the motor overload setting, while minimal, does need to be considered.
•
The Three Phase AC Out terminals allow for the connection of a second power supply, if more
than one is required.
•
The output voltage, while rated at 26VDC, is suitable for use with CRUZcontrol.
•
A T Cable is provided with the Power Supply Kit for connection to the Power Supply output
terminals.
