MANUAL P/N 900000165 REV H
35
7
Working with the TFS Network Management System
The status of the NTP80plus will be shown on the status tab for the particular time server.
There are five sources of possible alarm states. These relate to the status elements NTP overall
state, GPS system state and the ETHx ifOperState for each port.
For the NTP overall state the following will indicate a fault and turn the indicator red:
NTP
not loaded
NTP not loaded will be the case at start up, prior to first time
synchronisation. After this, unless the NTP service is reconfigured this
alarm will not be set.
NTP GPS
no GPS
Not synchronising to GPS. Check GPS status for reason. This will be
permanently set with a Peer-to-peer NTP80plus but will not cause an
alarm.
NTP Peer to Peer
no peer
Disabled for GPS NTP80plus. For peer to peer NTP80plus indicates that
NTP service has no peers to synchronise to and will therefore cause an
alarm.
NTP service
not present
.
NTP service fault. Consult Time & Frequency Solutions.
Summary of Contents for NTP80plus
Page 10: ...MANUAL P N 900000165 REV H 10 ...
