Textron Ransomes TMM48R, Operator Instructions Manual

Page: 21 / 30

19
3. Install mower lift pivot shaft.
NOTE: Installation procedures are different
depending on whether or not the tractor is to be fitted
with loader and loader valve, valve only or no loader
or valve. Select the proper procedure as indicated in
Figure 1 6 and 1 7 or 18.
When installing the mower lift pivot shaft and bracket
without loader or valve; Figure 16.
Insert the pivot shaft into the hole of the left bracket.
Fasten the left bracket to the pivot shaft with a
spacer, bolt and spring washer. Install loosely on left
side of tractor clutch housing implement mounting
pad using proper length bolts as shown. Insert two
stabilisers, three collars ( 7/33", 11/32", 1 ~/16")
and right bracket as shown. Install the lift links to the
pivot shaft using a washer and a split pin. Note 11/32
and
7/33 collars on left side.
Install the stabilisers to the lift links with two washers,
nuts and bolts on both sides, Figure 16. Attach the
brackets and up stop with a spacer on the left and
right sides of tractor clutch housing. See Figure 16.
PREPARING MOWER FOR OPERATION
Figure 16 - Installing the Mower Lift Pivot Shaft and the
Bracket without Loader or Valve