Textron Ransomes TMM48R, Operator Instructions Manual

Page: 22 / 30

20
3b. When installing brackets with mower and 2-
spool valve:
Insert the pivot shaft into the hole of the left
bracket. Fasten the left bracket to the pivot
shaft with a spacer, bolt and spring washer.
Install loosely on left side of tractor clutch
housing implement mounting pad using proper
length bolts as shown. Insert two stabilisers,
two collars (11/32", 1 9/16") and right bracket
as shown. Install the lift links to the pivot shaft
using a washer and a split pin. Note 11/32 and
7/32 collars on left side.
Install the stabilisers to the lift link with two
washers, nuts and bolts on both sides,
Figure 17. Attach the brackets and up stop on
left and right sides of tractor clutch housing on
the outside of the valve bracket. See Figure
17.
PREPARING MOWER FOR OPERATION
Insert two stabilisers, three collars ( 7/33", 11/
32",
1 9/16") and right bracket on the pivot shaft a~
shown. Install the lift links on the pivot shaft
using a washer and a split pin. Note 11/32
and 7/33 collars on left side. Attach the right
bracket to the clutch housing of the tractor on
the outside of the loader and valve mounting
bracket, see Figure 18.
NOTE: The up stop is not used when mower Is
installed to tractor equipped with a loader.
3c. When installing brackets for mower, 2-spool
valve and loader:
Insert two collars (11/32" left bracket, 7/33")
on the pivot shaft. Fasten the left bracket to
the pivot shaft with the spacer inside, see
Figure 18. Install the lift link to the pivot shaft
using a washer and a split pin. Install loosely
on left side of tractor clutch housing implement
mounting pad using proper length bolts as
shown.
Figure 17 - Installing Brackets for Mower and 2-spool valve