51
6-2-1.
Master-slave connection using joint kits
The joint kits faclilitate master-slave connection of two units and offer sufficient
rigidity.
How to Connect Units Vertically
(1) Remove the rubber shoes from the bottom of unit A. (Keep the removed
rubber shoes and screws with care not to lose them.)
(2) Fix the joint kit (JK-10) to the top panel of the unit B with the flat
countersunk head screws supplied with the kit. (Four positions)
(3) Place the units as shown in Fig. 6-2 below so that the projections of the JK-10
on the unit B are inserted in the holes in the unit A, from which the rubber
shoes are removed above.
(4) Shift the unit A, and fix the rear panel to the brackets of the joint kit (JK-10)
firmly with the screw with washer supplied with the kit. (Two positions)
Unit A
Unit B
Viewed from side
Unit A
Unit B
Shift and screw
Connection for Vertical Installation
Fix JK-10 with attached
Screw at 4 positions
2 positions
Fig. 6-2 Connection for Vertical Installation
