Odyssey X
Installation Manual
6
INS627-2
Odyssey X-W
(Premier Elite V2.11.X or later) Battery Insertion & Learning procedure
When installing a wireless sounder, the batteries should be installed and the device learned to the panel BEFORE it is mounted in the chosen
location. The sounder should always be the last fixed device learned and installed.
All other fixed devices should be in their desired location before learning the sounder
The following sequence should be used.
1.
Access the device as described on the previous pages.
2.
Install the batteries into the holder
3.
Connect battery pack to PCB
4.
Learn sounder to panel
5.
Make Jumper selection for LED ON/OFF
6.
Make Jumper Selection for Sounder Time
Odyssey X-W
PCB Layout
Symbol
Description
The battery pack should be connected here after
installing the batteries.
Powering the sounder on for the first time starts
the learn process. Once learned the "POWER"
jumper should be left in the "ON" position.
If you need to relearn the sounder, the link
should be moved to the OFF position for a
minimum of 1 second.
Enables or disables the comfort LED's. Disabling
the LED's significantly increases battery life.
The sounder on time is dictated by this jumper
position and is independent of the Bell On time
in the control panel. If however the panel bell
time is shorter than the jumper setting selected,
the panel will over ride the jumper setting.
Only Lithium AA 1.5V Type batteries should be
used
Alkaline batteries should not be used, they
will have a much shorter lifespan and can
freeze and fail to operate at -5
C
Used Batteries should be disposed of according
to the manufacturer's instructions.
The quoted battery life is an estimate and will
depend on the site conditions.
