30
6. Before start - fuel and chain oil
Mix leadless gasoline octane 95 with approved semi-synthetic 2-stroke oil
We recommend Tex-Part oil Motex 2 TX with a 2% mixture.
If other types of oil are used - a mixture of 4% is recommended - you shall
Always follow the guidelines of the oil manufacturer on the back of the oil can.
WARNING
Avoid open fire close to where you fill with fuel. Draw attention to the presence of dirt or
water in the fuel. Always store the fuel in a clean and approved container..
Use always chain oil for lubrication of bar and chain. Texas recommends Klingtex chain oil
viscosity 125.
7. Start
1) Fill with chain oil (1) and fuel (2)
2) Make sure the stop switch and chain brake is not activated
3) Release the stop/start switch (3)
4) Push down the safety button (6), at the same time as
the throttle control is activated (5). While both are being
held down the lock is pushed (4). The lock takes care of
start gas when the handles are released
5) Pull out the choker (7)
6) While the saw is kept safely on the ground with one foot
inside the rear handle and left hand on the front handle,
the starter handle is being pulled a few times with right
hand until you hear an explosion
7) The choke is now pressed in completely and the
procedure in (6) is repeated. Now the saw will start
8) Release the gas as soon as possible. Release throttle
control (5)
9) Let the saw warm up before using it
Warning: Keep clear of the chain as it will start moving
when the saw is started. Only start the saw when it lies
on a firm surface - never in the hand!
Note: If the engine is restarted just after it has been
stopped - the choke is not needed.
(3)
F8
(6)
(4)
(5)
F9
(7)
F10
F11
F7
Summary of Contents for TS450-18
Page 21: ...www texas dk 21...
Page 32: ...www texas dk 32 Note that Texas recommends Klingtex chain oil viscosity 125...
Page 34: ...www texas dk 34...
Page 37: ...www texas dk 37...