36
Bar. Clean the nose wheel and running path for dirt.
Turn if necessary the bar in order to spread the wear.
A worn bar can be dangerous to use and should be
replaced.
Chain. The chain should be filed on a regular basis
to obtain the best result.
1) Make sure the bar is tightened properly
2) Use a 4,8 mm (3/16 ) file
3) File all teeth down with 3-4 stroke, so that they are
even - as shown on the drawing
4) It is necessary to inspect the height of the teeth on
a regular basis, if they are too high, they should be filed.
Maintenance:
Part
After every use
After every
10th running
hour
After every
20th running
hour
Screws / bolts
Check / tighten
X
Air filter
Clean / replace
X
Fuel filter
Replace
X
Sword / driving
wheel
Clean
X
Sparking plug
Clean/adjust/replace
X
Fuel hose
Check
X
Replace
If necessary
Chain brake
Check
X
Replace
If necessary
17. Storage
1. Empty the fuel tank
2. Start the machine and let it run till all fuel has been used
3. Let the machine cool
4. Unscrew the sparking plug
5. Pour 1 teaspoonful of 2-stroke oil in the sparking plug gap
6. Pull the starting cord easily 2-3 times, thereby the oil is distributed in the machine.
7. Remount the sparking plug safely and place the sparking plug cap back in its place
8. Store the chain saw in a dry area
Summary of Contents for TS450-18
Page 21: ...www texas dk 21...
Page 32: ...www texas dk 32 Note that Texas recommends Klingtex chain oil viscosity 125...
Page 34: ...www texas dk 34...
Page 37: ...www texas dk 37...