6.1
A Example LUN Configuration
This section summarizes how to change the system memory configuration
from the default factory configuration to a new configuration, which
consists of four partitions and has access lists that allow only four host
machines to use the RamSan.
This demonstration assumes the four HBAs and the RamSan’s Fibre
Channel ports are attached to the same fabric. In addition, this system
has 16 Gigabytes of memory.
The new configuration consists of four partitions that HBAs access using
four Fibre Channel ports in the RamSan. This demonstration assigns each
HBA a unique LUN. The example results in the following configuration:
Figure 6-2: Reconfigured LUN Mapping
To change from the default configuration to the one described above,
perform the following steps:
2
Gigabytes
LUN 2
Port 2A
2
Gigabytes
LUN 3
Port 2B
6
Gigabytes
LUN 1
Port 1B
Fibre Channel
Ports
6
Gigabytes
LUN 0
Port 1A
HBA 1
HBA 2
HBA 3
HBA 4
•
Delete the default LUNs (see Section 6.8 )
•
Add two 6-Gigabyte LUNs (see Section 6.2 )
•
Add two 2-Gigabyte LUNs (see Section 6.2 )
•
Link each LUN to an Fibre Channel port (see Section 6.4 )
•
Add access lists (see Section 6.7 )
•
Set a backup mode for each LUN in a RamSan-320/325 (see Section
6.9 )
RamSan-300/320/325
User’s Manual
- 67 -
Summary of Contents for 320
Page 1: ...TEXAS MEMORY SYSTEMS INC RamSan 300 320 325 User s Manual Version 2 1 ...
Page 12: ...Figure 2 1 RamSan 320 325 Layout RamSan 300 320 325 User s Manual 8 ...
Page 110: ...Figure B 3 Power Supply Module Figure A 5 Memory Blade RamSan 300 320 325 User s Manual 106 ...
Page 111: ...Figure A 6 120 Gigabyte Replacement Hard Drive RamSan 300 320 325 User s Manual 107 ...
