www.ti.com
4.12.8 Video Display Field 2 Vertical Blanking End Register (VDVBLKE2)
Video Display Registers
Table 4-12. Video Display Field 2 Vertical Blanking Start Register (VDVBLKS2) Field Descriptions
(continued)
Description
Bit
field
(1)
symval
(1)
Value
BT.656 and Y/C Mode
Raw Data Mode
11-0
VBLNKXSTART2
OF(value)
0-FFFh
Specifies the pixel (in FPCOUNT)
Specifies the pixel (in FPCOUNT)
where VBLNK active edge occurs for
where vertical blanking begins (VBLNK
field 2.
active edge) for field 2.
DEFAULT
0
The video display field 2 vertical blanking end register (VDVBLKE2) controls the end of vertical blanking in
field 2.
In raw data mode, VBLNK is de-asserted whenever the frame line counter (FLCOUNT) is equal to
VBLNKYSTOP2 and the frame pixel counter (FPCOUNT) is equal to VBLNKXSTOP2 (this is shown in
In BT.656 and Y/C mode, VBLNK is de-asserted whenever FLCOUNT = VBLNKYSTOP2 and FPCOUNT
= VBLNKXSTOP2. This VBLNK output control is completely independent of the timing control codes. The
V bit in the EAV/SAV codes for field 2 is controlled by the VDVBIT2 register.
The video display field 2 vertical blanking end register (VDVBLKE2) is shown in
and described
in
.
Figure 4-38. Video Display Field 2 Vertical Blanking End Register (VDVBLKE2)
31
28
27
16
Reserved
VBLNKYSTOP2
R-0
R/W-0
15
12
11
0
Reserved
VBLNKXSTOP2
R-0
R/W-0
LEGEND: R/W = Read/Write; R = Read only; -n = value after reset
Table 4-13. Video Display Field 2 Vertical Blanking End Register (VDVBLKE2) Field Descriptions
Description
Bit
field
(1)
symval
(1)
Value
BT.656 and Y/C Mode
Raw Data Mode
31-28
Reserved
-
0
Reserved. The reserved bit location is always read as 0. A value written to this
field has no effect.
27-16
VBLNKYSTOP2
OF(value)
0-FFFh
Specifies the line (in FLCOUNT) where Specifies the line (in FLCOUNT) where
VBLNK inactive edge occurs for field 2. vertical blanking ends (VBLNK inactive
Does not affect EAV/SAV V bit
edge) for field 2.
operation.
DEFAULT
0
15-12
Reserved
-
0
Reserved. The reserved bit location is always read as 0. A value written to this
field has no effect.
11-0
VBLNKXSTOP2
OF(value)
0-FFFh
Specifies the pixel (in FPCOUNT)
Specifies the pixel (in FPCOUNT)
where VBLNK inactive edge occurs for
where vertical blanking ends (VBLNK
field 2.
inactive edge) for field 2.
DEFAULT
0
(1)
For CSL implementation, use the notation VP_VDVBLKE2_field_symval
SPRUEM1 – May 2007
Video Display Port
131