Texas Instruments TDA4VM, User Manual

Page: 80 / 84

Table 4-32. ENET Expansion Connector J10 Pinout (continued)
ENET Expansion connector Interface J10
Pin No Signal
40 QSGMII_PHY_REFCLK_P
41 DGND
42 QSGMII_MDC
43 QSGMII_MDIO
44 DGND
45 QSGMII_RESETN
46 CDCI_I2C_SEL
47 ENET_EXP_SPARE
48 DGND
49 VSYS_5V0
50 VSYS_5V0
51 DGND
52 NC
53 NC
54 DGND
55 VCC_3V3
56 VCC_3V3
57 DGND
58 NC
59 NC
60 DGND
SH1 DGND
SH2 DGND
4.25.4 Ethernet Interface
The J721E EVM includes SGMII connection between VSC8514XMK Quad Port SGMII PHY and the network
subsystem (NSS) of the Processor. One channel of SGMII interface (connected to stacked RJ45 connector J1A
and J1B, J2A and J2B) from the SERDES domain of J721E processor are used.
4.25.4.1 Quad Port SGMII PHY Default Configuration
The J721E EVM uses the 138-pin QFN package, designated with the XMK suffix that supports only the SGMII
interface.
The VC8514 device includes three external PHY address pins, PHYADD [4:2] to allow control of multiple PHY
devices on a system board sharing a common management bus. These pins set the most significant bits of the
PHY address port map. The lower two bits of the address for each port are derived from the physical address of
the port (0 to 3) and the setting of the PHY address reversal bit in register 20E1, bit 9.
4.25.5 Board ID EEPROM Interface
The Quad port Ethernet Expansion Board is identified by its version and serial number, which are stored in the
onboard EEPROM. The EEPROM is accessible on the address 0x54.
The first 259 bytes of addressable EEPROM memory are preprogrammed with identification information for each
board. The remaining 32509 bytes are available to the user for data or code storage.
J721E EVM Hardware Architecture www.ti.com
80 Jacinto7 J721E/DRA829/TDA4VM Evaluation Module (EVM) SPRUIS4D – MAY 2020 – REVISED MARCH 2022
Submit Document Feedback
Copyright © 2022 Texas Instruments Incorporated