![background image](http://html1.mh-extra.com/html/texas-instruments/sm320c6455-ep/sm320c6455-ep_data-manual_1097069247.webp)
www.ti.com
7.21.3 GPIO Electrical Data/Timing
GPIx
GPOx
4
3
2
1
SM320C6455-EP
FIXED-POINT DIGITAL SIGNAL PROCESSOR
SPRS462B – SEPTEMBER 2007 – REVISED JANUARY 2008
Table 7-114. Timing Requirements for GPIO Inputs
(1) (2)
(see
Figure 7-78
)
-720
-850
A-1000/-1000
NO.
UNIT
-1200
MIN
MAX
1
t
w(GPIH)
Pulse duration, GPIx high
12P
ns
2
t
w(GPIL)
Pulse duration, GPIx low
12P
ns
(1)
P = 1/CPU clock frequency in ns. For example, when running parts at 1000 MHz, use P = 1 ns.
(2)
The pulse width given is sufficient to generate a CPU interrupt or an EDMA event. However, if a user wants to have the DSP recognize
the GPIx changes through software polling of the GPIO register, the GPIx duration must be extended to at least 24P to allow the DSP
enough time to access the GPIO register through the CFGBUS.
Table 7-115. Switching Characteristics Over Recommended Operating Conditions for GPIO Outputs
(1)
(see
Figure 7-78
)
-720
-850
A-1000/-1000
NO.
PARAMETER
UNIT
-1200
MIN
MAX
3
t
w(GPOH)
Pulse duration, GPOx high
36P – 8
(2)
ns
4
t
w(GPOL)
Pulse duration, GPOx low
36P – 8
(2)
ns
(1)
P = 1/CPU clock frequency in ns. For example, when running parts at 1000 MHz, use P = 1 ns.
(2)
This parameter value should not be used as a maximum performance specification. Actual performance of back-to-back accesses of the
GPIO is dependent upon internal bus activity.
Figure 7-78. GPIO Port Timing
Submit Documentation Feedback
C64x+ Peripheral Information and Electrical Specifications
247