Quick Start
11
DLPU096 – November 2019
Copyright © 2019, Texas Instruments Incorporated
DLP5534Q1EVM Evaluation Module User's Guide
3. Select "Connection Settings" to confirm the SPI configuration shown in
matches the Controller
PCB switch settings described in
. Specifically, SPI mode and CRC/Checksum may vary based
on switch settings. Press "OK" once configuration is complete.
Figure 6. DLPC230-Q1 Automotive Control Program Communication Settings
4. Click the Connect button. The green circle next to the Connect button should then light up to indicate
that connection was successful to the Cheetah Adapter.
2.5
Steps to Reprogram the Onboard Flash Memory
The DLP5534Q1 EVM comes with onboard serial Flash that is pre-programed with software and basic
configuration. The software and configuration can be updated by reprogramming the serial Flash with the
DLPC230-Q1 Automotive Control Program. Steps to re-program the serial Flash are listed below.
1. Using the DLPC230-Q1 Automotive Control Program, which is connected to the EVM, navigate to the
"Flash Program" tab.
2. Using the folder icon, select an Image File (.bin) and open it.
3. Click "Program and Verify Flash Memory."
Note that if the device is in Display mode, it will automatically be switched to Standby during programming.
3
Optic Engine Requirements
The DLP5534Q1 EVM can be coupled to an optical engine (not included) and phosphor film (not included)
to implement a transparent window display function. The detailed requirements of the optical engine are
beyond the scope of this document, but the optical engine should have a 405 nm illuminator. Other
illuminators above 405 nm are also possible. A heatsink for the DLP5534-Q1 DMD might be needed for
operation in high temperature ambient environments, but is not included in the DLP5534Q1 Electronics
EVM.
