Quick Start
9
DLPU096 – November 2019
Copyright © 2019, Texas Instruments Incorporated
DLP5534Q1EVM Evaluation Module User's Guide
2
Quick Start
Use the following instructions to setup your DLP5534Q1 EVM and PC.
2.1
Kit Assembly Instructions
A diagram of all the EVM cable connections is shown in
1. Connect the Controller to Driver control Interface flex to the Controller PCB (J8) and the Illumination
Driver PCB (J502).
2. Connect the Host SPI cable to the Controller PCB (J2) and the Cheetah adapter. Connect the Cheetah
adapter’s USB cable to PC.
3. Connect the Controller Power cable to the Controller PCB (J11) and the Illumination Driver PCB (J6).
4. Connect the LED 1 Illumination output cable to the Illumination Driver PCB (J7) to the LED 1
illuminator in the optics engine.
5. If there is a second illuminator connect the LED 2 Illumination output cable to the Illumination Driver
PCB (J501) to the LED 2 illuminator in the optics.
6. If there is a third illuminator connect the LED 3 Illumination output cable to the Illumination Driver PCB
(J5) to the LED 3 illuminator in the optics engine.
7. Connect the Micro HDMI cable to the Controller Board (J3). Connect the Micro HDMI cable to PC
HDMI port.
8. Connect the Power Input cable to the Illumination Driver Board (J8).
9. If there are fans connect them to LED Driver Board (J1 and J2).
10. If fan PWM is utilized then connect the Fan PWM cable from controller (J10) to LED Driver (J3).
Figure 4. EVM Cable Connections
