Texas Instruments DLP5534Q1EVM, User Manual

Page: 3 / 12

www.ti.com
User Guide Overview
3 DLPU096 – November 2019
Submit Documentation Feedback
Copyright © 2019, Texas Instruments Incorporated
DLP5534Q1EVM Evaluation Module User's Guide
(1)
Port unused for this application. Cable not provided.
Table 1. Controller PCB Ports
SCHEMATIC REFERENCE FUNCTION
J1 Host I
2
C, PROJ_ON, HOLD_BOOT, HOST_IRQ
J2 Host SPI
J3 Micro HDMI
J4 OpenLDI (Flex connector)
J5 Photodiode 1
(1)
J6 TPS99000-Q1 SPI Debug
J7 Photodiode 2
(1)
J8 LED Driver Interface
J9 LED Thermistor
(1)
J10 Fan PWM output (optional)
J11 Controller Power
Table 2. Controller LED Indicators
SCHEMATIC REFERENCE FUNCTION
D4 (Green)
Input power to Controller (from Illumination Driver)
Off: No power connected
On: Power connected
D5 (Green)
PROJ_ON
Off: System Off
On: System On
D6 (Red)
HOST_IRQ
Off: Interrupt not asserted
On: Interrupt asserted
The Controller PCB switches are listed in Table 3 . SW4 is a toggle switch for PROJ_ON which is used to
turn on and off the electronics. Note that parts of the board are still powered when PROJ_ON is in the off
position. SW1, SW2, and SW3 are dip switches that control the states of configuration signals the
DLPC230-Q1 reads when it comes out of reset. These switches should be set based on the desired
configuration options.
Table 3. Controller PCB Switches
SCHEMATIC REFERENCE /
SIGNAL NUMBER
FUNCTION
SW1 (1)
Spread Spectrum Enable
Off: Disabled
On: Enabled
SW2 (1)
Host Port Checksum Select
Off: CRC
On: Checksum
SW2 (2)
Host Interface Select
Off: Host SPI
On: Host I
2
C
SW2 (3)
Host SPI Mode
Off: Mode 0 or 3
On: Mode 1 or 2
SW3
Hold in Boot
Off: Do not hold in boot (continue to main application)
On: Hold in boot
SW4
PROJ_ON
Off: Turn off system
On: Turn on system
On state is toward the closest corner of the board
Figure 1