www.ti.com
Quick Start Guide
2.3.4
HSDC Pro GUI Configuration
Inside the HSDC Pro GUI, select ADS54J66_LMF_4421. If prompted to update the firmware for the ADC,
click “Yes” and wait for the firmware to download to the TSW14J56. This will take about 3 seconds. Enter
“491.52M” into the
ADC Output Data Rate
field at the bottom left corner then click outside this box or
press return on the PC keyboard. The GUI will display the new lane rate of the SerDes interface based off
of the sample rate and other parameters from the loaded configuration files. Click ‘OK”. Click the
Instrument Options
menu at the top of HSDC Pro and select
Reset Board
. Make sure the display mode is
set to "Real FFT". Click “Capture” in HSDC Pro to capture data from the ADC. The results from the
captured data of Channel 1 should look like
Figure 6
and the performance should be similar to
Table 2
. If
this result is not achieved, then see the
Quick Start Troubleshooting
section of this document.
Figure 6. Channel 1 Data Capture Results in Bypass Mode
Table 2. Quick Start Performance Measurements
Result
Measured Value
Units
SNR
69.04
dBFS
SFDR
85
dBFS
9
SLAU641D – June 2015 – Revised January 2016
ADS5XJ6X Evaluation Module
Submit Documentation Feedback
Copyright © 2015–2016, Texas Instruments Incorporated